Laundry/Drain Pump Systems

Comments 66 Typical costs: The traditional dig-up-and-replace method requires excavating a long, deep trench or trenches to remove the old pipes and install new ones. Trenchless sewer replacement uses minimal digging with one of several methods — pipe-bursting, in which a machine breaks and pushes out the old pipe while pulling through and installing a new pipe in its place. Smaller projects generally cost more per foot. Traditional dig-and-replace sewer work can require a lot of invasive excavation and result in a patched-up yard, but can be a relatively simple project; an excavator digs up the old pipes, new ones are installed and the trench is refilled. A California plumber provides a video of replacing old clay piping using traditional methods[ 1 ]. Trenchless methods are usually faster than the traditional approach, but require at least some digging, usually at each end of the existing pipe and anywhere in-between where it bends or turns.

Troubleshooting The Ejector Pump

Type keyword s to search Sump Pump Installation Made Easy If you have water problems in your basement that you’ve been ignoring, there’s a good chance you’re losing up to half of your home’s living space. And at the cost of housing these days, that’s a substantial loss. While water that collects in a basement may originate from several possible sources, almost all such problems can be corrected.

And for many, the simplest solution is to install a sump pump. While a pump doesn’t cure the disease, it goes a long way toward treating the symptoms.

The entire paper industry in recent years has worked to develop more and more flushable items:

This is due to the fact that melting snow and rainstorms often coincide. As a result, flooding becomes a very real problem. Cold temperatures frequently occur during these months as well, which may lead to a frozen drain line on the sump pump. If the drain line is frozen, the pump will fail in its function to evacuate water from the basement, leading to a potentially severe and costly problem.

Fortunately, with patience and time, it is possible to thaw the pump’s line. Step 1 Cut off the power to the sump pump. Switch the pump off, unplug it or turn it off at the breaker box.

Sump Pumps – Don’t Make These 3 Mistakes

Step Two — Locate and bury tank Locate the tank that will receive waste water near the sewer line that runs to the approved sewage system. Dig a pit large enough to hold the tank and as deep as needed to place the tank inlet at the lowest elevation for all drain lines that will run into it. Level the tank and fill it with water to ensure it doesn’t move.

Connect the drain pipes to the tank, then backfill and compact dirt around the tank. Complete all cement flatwork before proceeding, taking care to prevent any dirt, cement or debris from entering the tank.

With the pilot hole in place, use a larger bit to drill a hole large enough to fit the drain pipe.

If you’ve got a consistent problem with water in your basement, you can learn to diagnose your problem and decide if a sump is right for you. Steps Diagnosing the Problem 1 Check out your basement during a good rain. Most basement water problems aren’t the result of problems in the basement, but the result of poor outdoor drainage. Before you go tearing up your basement, check to make sure you don’t have other problems first.

Make sure your gutters are unclogged and free of leaves and other debris, and that water can flow easily through them into the downspouts. The downspouts should dump water 4—5 feet 1. Make sure the soil around your foundation slopes at least a couple of feet away from the house. If you’ve got pits that catch the water and force it downward, you might have problems getting water in your basement.

How to Fix a Frozen Sump Pump Line

Paul, Minnesota – Latitude The sewers were called common sewers an comtained normal sewage that took treatement and storm water that usually didn’t require treatment. Then they found out it was costing a fortune to treat all the storom water AND the sewage since it could not be separated once it was in the pipe. On top of the treatment cost, there was the cost of building and maintaining twice the treatment capacity.

Now, it is illegal to make new hook-ups in most areas.

The sizing determines the cost of the package system and basin.

If a sump pump’s discharge line sends the water into the wrong part of this yard, a much of the water it pumps out will end up back in the basement. Your sump pump is the heart of your basement waterproofing system. If it stops, then your basement floods. How you design your sump pump discharge line is key to preventing clogs and keeping your system running without interruption.

It’s also important to remember that what happens outside of your basement can have a major impact on how much water leaks into your basement. Keep water away from your foundation, and it won’t be able to leak into the basement. Our basement experts can help you design a complete waterproofing system — one that takes all aspects of waterproofing into consideration.

To schedule your free basement waterproofing quote , call or e-mail us today! Features Of Our Sump Pump Discharge Lines Issues with sump pump discharge lines can lead to a clogged system or a system that is forced to run continually, shortening the life of the sump pump. Including a few failsafes within your system can make the difference between a properly working system and a flooded basement.

As part of our basement waterproofing services , we will include several failsafes that help to ensure a properly operating system. Our sump pump discharge lines include the following four features: A Sump Pump Check Valve The sump pump check valve is a section of the discharge line black, in the photo to the right.

Sewer Line Replacement Cost

The pump is only used for dewatering the foundation soil; nothing else drains into it. I live in Rochester NY, which does allow connecting sump pumps to sanitary lines, which is probably the most reasonable option. I could entertain discharging to the outside, but there’s not much avenue for that, given the geography and how little land there is around my house. The sump is located 2 feet to the right in the below picture; discharge tube isn’t connected yet.

Bottom of the discharge has a standard check valve. I was wondering what is the correct way to tie the sump discharge into to the sewer stack, pictured below:

Early Summer We are increasing the size of the system to TRIPLE the original capacity and building it on a raised platform for better water pressure and gravity flow.

Our sewage has been backing up. Right next to the pipe connecting our house to the sewer line running down our street stands a year-old willow oak, and I worry the tree’s roots have found their way, during the droughty past year, into our line. Maybe it’s tree roots, maybe it’s a collapsed pipe, maybe it’s a yo-yo. The snake went in only a dozen feet or so and found a clog, and now the little claw at the end is spinning.

Once he pulls it out we’ll know better what’s going on. I leave him to his business, though I cast an annoyed glance at the oak. Sewer pipes fit together simply, with a bell joint, and tiny root hairs find their way to the nutrient-rich flow, then grow larger, eventually growing large enough to shatter the vitreous clay pipe that forms so many service lines or dislodge a joint if the pipes are cast iron. Nobody knows what our pipes, 70 years old, are made of, but I fear we’re about to find out.

Fifteen minutes later he’s winding the snake back up, writing a bill, and exonerating the oak. The entire paper industry in recent years has worked to develop more and more flushable items:

DIY 275 Gallon Rainwater Collection

Sewer Gas Smell Tips Just Below Source of the odor is usually where it’s strongest What happened just before you started smelling the odor? Did you get a new washing machine or have a drain cleaned? Does something happen just before you smell the odor? My daughter’s house has a chronic sewer gas odor problem. The odor is strong when it rains and the furnace or air conditioner is operating.

The odor gets so bad my daughter and her family evacuate the house.

Very pleased with his work.

The system is based on an industrial gallon container, known as an IBC. You can buy them used, or if you really look around, you can even find them for free. One problem with typical rain-barrels is that they can only collect 55 gallons. This rain storage container collects FIVE times that volume, while not taking up all that much more space than a single rain-barrel. Those come with a metal cage around them that allows them to be stacked. These containers come to the bottler full of gallons of high-fructose corn syrup.

I got several containers from them for free, for just the elbow grease of going to pick them up. Some were wrapped in heavy cardboard. I recycled the cardboard into a clubhouse for my little girl. After washing the container out well, it is ready to be repurposed for rainwater collection. I really like the irony of using GMO corn syrup containers to recycle into a conservation project!

How Does Sewage Treatment Work?

Sump Pumps – Don’t Make These 3 Mistakes September 30, by Adam Comments I have provided several basement waterproofing tips and have contended that by taking these steps, you can avoid water in your basement. However, there is an old adage about basements: They sit on a bed of gravel or rocks at the bottom of sump pump pit.

The discharge pipe is hooked up to that circle-jobby on the left. Your basement WILL get wet eventually.

We cut the downspout a few feet above the container, and then set the cut-off piece to the side for later use.

These pumps are activated when the water reaches a certain depth in a sump pit. From this point, the water must be removed from the pit in such a manner as to prevent it from easily flowing back into the area from which it was removed. You must keep several considerations in mind as you plan how to pipe the discharge line from your sump pump.

In many areas it is illegal for you to tie the drain into your municipal sewer system. Municipalities like to control, as well as charge for, both the water that comes into your home from their water system and the water that leaves your home via drains to their sewer system. If your city does allow connection to your sewer drain line, this is by far the easiest and most efficient method of plumbing the sump pump discharge line.

Step 2 Secure a short section of PVC pipe to the discharge port of the sump pump.

How Much Does It Cost To Install Or Replace A Sump Pump?

So many people rely on the functionality and durability of a sewage ejector that knowing how to do some minor diagnostics and repairs are a must for the homeowner. And you can find reviews and descriptions online to help find out which one will fit your needs. Ejector pumps are used when a bathroom or laundry room fixture is located below the grade of the main sewer or the septic line. They allow for the flow of solids and liquid to work against gravity and be pumped from the basement up to different parts in the house like to a house sewer or sink.

For vertical style floats, check adjustment of rubber stopper under the float ball at the bottom of the float rod.

This data is based on actual project costs as reported by HomeAdvisor members. Sump pumps work almost every day moving water away from your foundation to keep your house from flooding. They are usually located in your basement in the lowest point in the floor in a hole called the sump hole. Any water that flows into your basement will make its way to this lowest point.

Your sump pump hooks up to your wastewater drain. When water enters your basement, the pump pulls it away from your foundation into your wastewater system and keeps your basement from flooding. There are a few major factors that will affect the cost of your sump pump installation. If your home already features a sump pump, failure may require replacement. In that case, your costs decrease slightly, as some of the below variables are already taken care of.

Return to Top Types of Sump Pumps There are two main types of sump pumps that are most commonly installed in people’s homes; submersible and pedestal.

How to Pipe Sump Pump Discharge

Tweet Sewer Smell — Washing Machine Plumbing Trap Problem Recently a good friend of mine asked me what might be causing his laundry room to have a sewer smell. Obviously this was a serious problem that needed to be corrected immediately. Not only are sewer gasses an unpleasant experience but they can be a safety concern. If you smell sewer gasses in your home you should try and diagnose the problem sooner than later.

I started quizzing my friend about any recent changes in their home that might have contributed to the sewer smell.

Maybe I’ll use some on my lawn.

He called within about an hour. After explaining my situation and telling him that the other plumbing company said my well was no good and that I should have a new well drilled or hook up to city water he said that wells do not usually quit without any warning. He suggested that I hook up a hose to the neighbors hose to run water to my pump to prime it. He said if this did not work he would come out and check it out. When I did this I discovered that the pressure gage on the pump had rusted through and water was pouring out.

I was able to replace the pressure gage myself and restore water service to my home. I am very grateful to this plumbing company for making my situation a priority and for making suggestions over phone that helped solve my problem.

How To, Sump Pump Set Up and Install, Step by Step Instruction Including Perforated Pipe Connection